The Original CZ Forum
CZ PISTOL CLUBS => CZ 2075 RAMI CLUB => Topic started by: jack76590 on October 21, 2018, 06:25:37 PM
-
I have both a PCR and Rami so this question would probably apply equally to both pistols. I have found that most semi auto pistols develop quite a bit of crud in firing pin and extractor area after a few thousand rounds. So my questions are: 1. how often do you detail strip and clean slide? 2. how often, if ever, do you replace pins, springs or other parts, eg each strip, every 2nd or 3rd strip, etc? 3. What size punch pins are needed to remove firing pin retaining pin and extractor pin? I intend to replace existing firing pin retaining pin with the Cajun spring steel version. Thanks for any feedback.
-
Most of the answers to your questions can be found on CZ website, regarding maintenance. I detail strip probably more than I need, which is every 500 -700 rounds.
My 3/32 punch seems to drive most pins out. I normally change out most springs, pins, and trigger parts out with CGW products shortly after I buy a new CZ. But that's just me.
Sent from my XT1585 using Tapatalk
-
Most of the answers to your questions can be found on CZ website, regarding maintenance. I detail strip probably more than I need, which is every 500 -700 rounds.
My 3/32 punch seems to drive most pins out. I normally change out most springs, pins, and trigger parts out with CGW products shortly after I buy a new CZ. But that's just me.
Sent from my XT1585 using Tapatalk
TNman,
Do you restake your extractor pin when you remove? I have been reading some varying opinions on whether it is necessary, thanks.