The Original CZ Forum

CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: cnutinsky on November 28, 2018, 04:58:03 PM

Title: CZ P10-c slide release and mag release
Post by: cnutinsky on November 28, 2018, 04:58:03 PM

Picked up a CZ P10c and went to range.
Found the slide release and magazine release to be VERY difficult.
Not novice to pistols and without a doubt the most difficult releases to manipulate.
Is this unusual and will they loosen up with use??

Title: Re: CZ P10-c slide release and mag release
Post by: fondblanc1 on November 28, 2018, 06:34:29 PM

My P10c was the same. Ran it hard at the range and it loosened right up. Runs like a champ now.


Sent from my iPhone using Tapatalk Pro

Title: Re: CZ P10-c slide release and mag release
Post by: moengiant on November 29, 2018, 04:35:19 PM

I just picked one up and was thinking the same - I saw where someone polished the slide stop and that helped with the slide release as well others have done the same with the mag release. However I have heard that is will loosen up as well with use.   

Title: Re: CZ P10-c slide release and mag release
Post by: 2morechains on November 29, 2018, 07:43:35 PM

First I tried the ?just shoot it? break in method (3K-ish rounds), then I tried the ?polish it? method (made it somewhat better), finally I bit the bullet and ordered the Apex Competition Mag button (extended).  I should have just skipped the first two and gone straight to #3. 

https://store.apextactical.com/WebDirect/Products/Details/193028

Title: Re: CZ P10-c slide release and mag release
Post by: Indy_Tim on November 30, 2018, 12:24:23 PM

I did a bit of polish work on my first P10C and it loosened up immediately.  On my second, I just shot it in and within the first 300 rounds, both were fine.  They are now to the point where they represent what I think all pistols should feel like.