The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Joe L on March 22, 2019, 03:50:59 PM
-
Mountains of New Mexico instead of a bullseye match this weekend. I only brought my P-10's this weekend, and I am glad I did. This went well...
https://youtu.be/cVqUkVm-Nwo (https://youtu.be/cVqUkVm-Nwo)
I need to practice two handed standing. I may do that again tomorrow. Lots of fun shooting steel, if it doesn't blend with the background as much as this one!
Shooter needs work. Dang plastic striker gun is perfect, near as I can tell. Let's just say I am enjoying my CZ Forum Christmas present!!!
Joe
-
WOW! You're a MUCH better shot than I.
Can't wait to get to the range with my new P10s.
(https://lh3.googleusercontent.com/6xWogXxlbqWW3T0Ju5t0Cb5ufvv3HvGGjEAgJzFtRKWV5EKyoBeNnzSFm0djoanBRAuehxKJde6MNewFY81qGyQIQBl_2iBORy5p84d71L7lp4vA1ysYO4Jfr49PsYcZutBBFAbQPdgz4oQhibuaR2lfqxu6PulRzOC7o489DNBjkPBrU43fbRlIPw_QTrO-TYLmMOpE00s4J0xqXUCboejJm2X7DhfHLK7TFC0XkhwWdf8rKs-oJxt2zutWRZGXAXS3UWEctOdtKCd0ewRXGyRSV5JTONLsaVhqTyAGiPnxt-Y-I-lUeGEZ2as5Tz4fuqVv4w2IOhTpS_timKpGh9Yq9NYYxhR8d0MTgNGjIA2MtLa_TiaDHru5k7zDUMzwMnY60_CjBETYc-9rTQW-6sfMuK5yNPLbU_yK8Haqp09vCr5pYHBa6JDxyL_f_7rU04TZsAC7Tz0lhcz-fbKhYhCgZzoDKGZCk_39aPnOZHyAnhe19zzTj2N2SpSzByDZH4fyQmUsYgVfYZljzWQdQcio9HJrRYSpXHCiilULLdHztcS5mnzUPv71kL7wWMr-9kCPiF9qup2jyHVJwI7ZG4V-KR5swez0sHulMau39hiXuwPPWTj_ZWHwZFirvmJgAKolBS4CC1h4nnOyRcOkDTVlHk-oHVs=w638-h516-no)
-
WOW! You're a MUCH better shot than I.
I'm older. :) :)
Joe
-
Wiser to right Joe
-
I hope I'm wiser!
Here is the part of the video that shows more about the range setup than I included in the shooting video. The audio is bad on these clips, so I cut them from the main video. This is out of sequence. I shot the intro clips just after shooting the gong. I had already shut off my audio recorder. Shooter error. Not surprising.
https://youtu.be/afBe0d7BuuQ (https://youtu.be/afBe0d7BuuQ)
Joe
-
Wow, you rock, sir!
-
not surprised i was teasing a clay at 100 with my p10f. these things are silly accurate so far
-
not surprised i was teasing a clay at 100 with my p10f. these things are silly accurate so far
Good to hear. I remember when I first started shooting my P-09, I thought I had the oddball gun, but turned out most everyone was having good results from their P-09 as well. I'm hoping the P-10F is going to be the same.
Joe
-
I knew the US made P-10s were going to be silly accurate when I did those weak hand shots with the wifes P-10S. Massive impressive.
Joe, I would seriously recommend on replacing that steel gong ASAP - those craters are going to create high speed bounce back.
-
AM--OK, I will tell the range people, enough is enough. Good point. I did put the target camera back a little more than usual, just because I wasn't sure where the splatter was going. The steel targets were very heavy is all I can say. Except for the flipper. It's axis wasn't vertical so it will take more than a puny 9mm paper gun to make it flip.
Joe
-
Which Spring mount did you use? I looked at their sight and I can't see a P-10F mount listed. Did you use the P-09 mount? Thanks for the video.
-
How is it your slide to frame fit? Does it rattle shaking from side to side?
-
How is it your slide to frame fit? Does it rattle shaking from side to side?
Only when it is locked back, but not with the slide forward.
Joe
-
Which Spring mount did you use? I looked at their sight and I can't see a P-10F mount listed. Did you use the P-09 mount? Thanks for the video.
It is the one for the 75 Shadow. I have heard it isn't available from Springer any longer. Even then, I had to add a 0.010" shim and trim some material off the back ledge.
Joe