The Original CZ Forum

CZ LONG ARMS => CZ Scorpion EVO => Topic started by: Hanovi1982 on May 18, 2019, 09:50:07 PM

Title: Trigger pack screw
Post by: Hanovi1982 on May 18, 2019, 09:50:07 PM
I did my research and attempted to remove the screw put oil on it first and it still stripped going to have to drill it out. Does anyone have the correct screw that I could buy off them thanks for the help
Title: Re: Trigger pack screw
Post by: shootingsight on May 18, 2019, 10:40:20 PM
I have 'sort of' the correct screw.  Mine is a US sourced one, and uses a 2.5mm allen, instead of the 3.0mm allen.

However, the good news is that I'll send it to you for free if you email me your mailing address.

art@shootingsight.com
Title: Re: Trigger pack screw
Post by: DanT on May 18, 2019, 11:37:35 PM
I got a replacement for mine at the local Ace hardware.  Yes, it was metric.  Take you trigger pack with you to check for size.

- DanT  Phoenix, Az
Title: Re: Trigger pack screw
Post by: Hanovi1982 on May 30, 2019, 02:00:11 PM
Shootingsight thank you got it and it worked perfect
Title: Re: Trigger pack screw
Post by: cjive134 on June 03, 2019, 12:25:02 PM
I will have to look at what I bought at Fastenal. The info is out there though if you do the googles.
Title: Re: Trigger pack screw
Post by: Fragman on June 07, 2019, 08:38:59 PM
OK, a bit late for the OP as he got the screw out. But, just in case anyone else stripped their screw......

Evidently, the screw is not made of the hardest of metals. Combined with the fact that , at least on current production, a significant amount of loctite has been applied, it's not hard to strip the screw out.

Researched and found suggestions for soldering irons, dremels, drilling etc. Too easy to do real damage. Tried cutting a slot, but again, slightly wrong angle and can cut what you don't mean to. Besides, how are you going to get a good angle to use the slot effectively.

In the end, took the original 3mm T type allen wrench I had tried in the beginning.. Placed the lower upside down on top of a padded vice, spread open enough to clear the ejecttor and hammer.

Inserted the allen key into the screw like normal. Gave the T handle about a dozen firm hits with the hammer (not too hard, use your common sense). Now the T allen wrench had plenty of 'bite'. Took that screw right out.

So, my suggestion, if it even STARTS to strip the screw, just give a few taps with the hammer and you should be good to go.

You all provably know thos already! but thought I would share just in case.