The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: virgil on July 08, 2019, 10:05:57 AM
-
Just curious if anyone else is having this problem.... no matter which magazine I use in my p10f, it will not chamber a round with a full mag..I have to take one round out of the mag and then it will chamber..
-
If everything is brand new, try using 1500 grit sandpaper and sand the feed lips on the mag slightly to remove any burs or rough edges and then polishing the feed lips on the magazine with a dremel. Sometimes with some guns you can't get all the rounds it's supposed to take
-
Just curious if anyone else is having this problem.... no matter which magazine I use in my p10f, it will not chamber a
round with a full mag..I have to take one round out of the mag and then it will chamber..
You're saying that when you put in a magazine when the slide is open when you slingshot the slide closed it will not chamber a round?
Or are you just saying it's hard to put the magazine in with a full mag when the slide is closed?
-
Doc, a mag loaded to full capacity when inserted with slid open will not chamber. Catches on ramp EVERY time.. if I remove one round, there's no problem. I have a bunch of guns and this is the first time I've encountered this....
-
Doc, a mag loaded to full capacity when inserted with slid open will not chamber. Catches on ramp EVERY time.. if I remove one round, there's no problem. I have a bunch of guns and this is the first time I've encountered this....
I would do the magazine feed lips anyway that's what I do and many have recommended it. Also pull out the barrel get out a round oblong felt tip for your Dremel polish the feed ramp and on the outside edge of the chamber.
-
Virgil, please post back with your findings and results so others will know.
-
Cajun G.W. says to fill mags to full capacity and let sit for a couple weeks.. They say it's a common spring tension issue that should correct itself...
-
Might have something to do with the fact that they use the same spring for the 19 rounders that they do for the 19 rounder with the +2 base pads (21 rounders). I've only ever had used 19 round mags in my P09 and any of the new mags I've bought have been 21's, so I find this interesting
Sent from my H8266 using Tapatalk
-
Might have something to do with the fact that they use the same spring for the 19 rounders that they do for the 19 rounder with the +2 base pads (21 rounders). I've only ever had used 19 round mags in my P09 and any of the new mags I've bought have been 21's, so I find this interesting
Sent from my H8266 using Tapatalk
That would certainly explain it. Really surprised that QA didn't catch this early.
-
I don't have P10 F but I know that is very difficult loading 19 rounds into a P-09 which shares a magazine . I would only load them to 18 . With a 2 plus base I could get in 20 .
-
Take 1 round out and shoot the crap out of your Gun! In about a month or so having shot the Gun a lot try a full Mag....Gun will loosen up and should be normal if not, send to CZ. If, there is still problems I'll bet it's bad Mags!