The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: greyling22 on July 28, 2019, 04:37:50 PM
-
I've handled every gun known to man, and the p10 feels the best to me. Has the 2nd best trigger too. So it looks like a winner, But the only reviews I have seen about people actually running a p10 with a suppressor are the 2 from the truth about guns guy, and he had issues with light loads. Well guess what, I run light loads to keep them subsonic in the 8" SBR. I'm concerned that if I buy the p10 I will have issues with cycling. My can is on the heavier side.
Has anybody run a can on their p10? did it work? if not, is there a lighter recoil spring available that would fix the problem? How was it as a host? quiet? gassy?
-
You can run a lighter spring, but after mine broke in it cycles pretty much anything with a can.
Sent from my iPhone using Tapatalk
-
is there a source for a lighter spring? or do you cut the factory down?
-
CGW sells 15 and 18 lb springs for the P10C. You’d have to get their guide rod, or cut the end off your stock captured guide rod. I haven’t tried it, but people said they’ve used Glock 19 springs if you want to go lower than 15 lbs.
-
Recently picked up a new suppressor ready P10c. First outing to the range I was shooting mostly my subsonic 147 grain reloads (900-960 FPS), both with and without a suppressor, and some 115 grain factory fmj ammo. At first, there were a few of the lighter charged reloads at the lower velocity range where the gun didn’t always eject the spent case or fully close the slide when cycling in a fresh round from the mag when the suppressor was on. However, after the first 75 or 100 rounds, it was running great with no issues. Probably put a couple hundred rounds through it, mostly subsonic, and about half with the suppressor on. Didn’t notice much blowback or mess when shooting suppressed. Fairly quiet with the sub loads and a Silencerco Octane mounted. I like it.
Sent from my iPad using Tapatalk