The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: K.O.A.M. on November 17, 2019, 02:03:49 PM
-
Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.
-
Primary Machine (http://primarymachine.com/cz-slide-milling/) will mill your slide for you.
I don't have an Acro, but I had them mill my P10C for an RMR cut and a Glock dovetail in front of the optic. They also refinished my slide with Cobalt Cerakote and installed my sights for no extra charge. They mounted my Holosun 507C and it's a very tight fit in the slide. I was very pleased with their work and also sent my P07 slide to them for the same thing. Turnaround for the P10C was three weeks.
(https://i.imgur.com/uorzo4b.jpg)
-
Has anyone had their P-07 milled for an Aimpoint ACRO? I'd like to get mine done and was wondering if anyone had recommendations.
Thanks in advance for your help.
We have a couple in queue to do for a customers. Will post up when done.
-
I'll put my Kudos in for primary machines, they did my po9 for a Vortex Viper and cerakoted the slide beautiful work. The Optic in the slide is very tight, I don't think you could put a hair between the optic and the slide. When I practice I draw from Kydex holster every time and there is no wear of the cerakote on the slide.
-
Bringing this back, ATEi did a first rate job and I'm happy with the results. They use their "shim sight" on the rear which gives a nice lower 1/3 cowitness.