The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: 01svtL on November 19, 2019, 12:04:01 PM
-
So I'm using a PMM compensated P10C slide on my P10F frame. It runs perfectly fine with normal fire. I probably put 3-400 rounds through it without a single issue with normal target shooting. At my match on Sunday, I had two FTE's during the "double tap" on a paper target, two different stages. I didn't pay attention to what mag I was using when they happened. These are the first two FTE's I've had with the comped C upper regardless of the lower used, and being that it was while doing "double taps" I'm thinking the recoil spring should be lighter. Does anyone know what parts are compatible with the C upper? Should I just get a stainless guide rod and try a Glock 19 15# spring or something?
-
P07 guide rods and springs are the same as p10c guide rod and spring. I'm not sure if it's the same for 09 and 10f. I've run a 14 or 15 pound spring on my comped p07/p09 and never had a problem
Sent from my H8266 using Tapatalk
-
P07 guide rods and springs are the same as p10c guide rod and spring. I'm not sure if it's the same for 09 and 10f. I've run a 14 or 15 pound spring on my comped p07/p09 and never had a problem
Sent from my H8266 using Tapatalk
Thanks! What guide rod and springs have you been running?
-
I think cgw for both, cheaper than primary machine
Sent from my H8266 using Tapatalk