The Original CZ Forum
CZ LONG ARMS => CZ Scorpion EVO => Topic started by: Jason248 on February 07, 2021, 02:49:17 PM
-
Anyone know where to find one?
Used half a bottle of the bob smith debonder and my regular 20mm wrench isn’t cutting it! I must have the worst case scenario of loctite on this thing! Funny thing is the trigger pack screw came out easy with no loctite in it at all!
If anyone in southern MN happens to have one I can borrow that would be cool too!
-Jason
-
CZ Custom has them last time I looked. Think HB Industries has them as well. Good luck.
JW
-
Both oos unfortunately
-
Don't recall CGW advertising them, but they might know where one could be located.
Sorry I can not be of more help.
JW
-
I ended up saying F it and cutting the end of the hand guard off and heating it with the torch and it came off....
An absolutely insane amount of loctite was on there, all of the threads were covered and a pile of it ended up on the floor after I got it off. Even the spacer was covered in loctite...
Crazy. The new hand guard is on with much less loctite!
Thank you
-
Guess they really did not want it to move. Agree crazy.
JW