The Original CZ Forum

CZ PISTOL CLUBS => CZ75, 75b, 75 SAO inc the Transitional => Topic started by: ScottH on February 12, 2021, 02:44:49 PM

Title: Deformed hammer pin hole?
Post by: ScottH on February 12, 2021, 02:44:49 PM
I may have seen this on here some time in the past, but can't find it now...My '96 Turkish over run has an odd shaped pin hole..I swear I've seen info on it here, but...Any info you guys can supply will be absorbed and appreciated.
(https://i.imgur.com/lw3E24J.jpg?1)

Are there others out there? Any significance?
Title: Re: Deformed hammer pin hole?
Post by: ScottH on February 13, 2021, 10:10:30 AM
Anyone ever seen one like this? The more I search, the less I find...
Title: Re: Deformed hammer pin hole?
Post by: M1A4ME on February 13, 2021, 11:42:33 AM
Almost looks like it was cut for a pin with a tab on the end.

Only idea that comes to me would be to make it easier to pull out once you got it started from the other side.  Push the other side, slide a finger nail or knife blade under the tab and pull the hammer pin out.
Title: Re: Deformed hammer pin hole?
Post by: Tok36 on February 13, 2021, 11:51:13 AM
First time i have seen that one. Some folks pay to have similar stuff added to their slides. Maybe it is a Turkish speed dimple. :D


Title: Re: Deformed hammer pin hole?
Post by: ScottH on February 13, 2021, 11:55:25 AM
I was thinking maybe a machine or machinist boo boo? A factory blem?
Title: Re: Deformed hammer pin hole?
Post by: ScottH on February 21, 2021, 01:02:50 PM
Found it! In the thread "CZ steel frame compact decocker" There are two other guns with the same odd hammer pin hole...
(https://i.imgur.com/5I7R1RU.jpg?1)

(https://i.imgur.com/1KMEMLx.jpg?1)

One pic has arrows, and the Hammer pin hole circled....but the info was written in German, I think. NOT english at any rate. Now my curiosity is killing me....
Title: Re: Deformed hammer pin hole?
Post by: buddyd157 on February 21, 2021, 04:57:22 PM
Quote from: ScottH on February 21, 2021, 01:02:50 PM
Found it! In the thread "CZ steel frame compact decocker" There are two other guns with the same odd hammer pin hole...
(https://i.imgur.com/5I7R1RU.jpg?1)

(https://i.imgur.com/1KMEMLx.jpg?1)

One pic has arrows, and the Hammer pin hole circled....but the info was written in German, I think. NOT english at any rate. Now my curiosity is killing me....

is this hole on both sides?

my only guess would be, (if it is on both sides), that it allows  the hammer to drop down a bit further  maybe during rapid firings?
Title: Re: Deformed hammer pin hole?
Post by: ScottH on February 22, 2021, 07:19:45 AM
Not on both sides. Only the left side...
Title: Re: Deformed hammer pin hole?
Post by: ScottH on March 11, 2021, 10:33:29 AM
MAN! There has GOT to be a reason for this odd milling. Please speak up if you know...