The Original CZ Forum
CZ PISTOL CLUBS => Compact CZ 75s => Topic started by: briang2ad on February 22, 2021, 03:46:14 PM
-
CZ USA does not have them in stock and hasn't for weeks - so if you lose it, your gun is DOWN hard.
(Don't ask me how I know).
[but praise be for CGW - they have them].
-
I have plenty of spares. I always order a few of those with any order I place.
-
I have plenty of spares. I always order a few of those with any order I place.
Smart. I will NOT get caught without these ever again. I also have the detent springs for the Omega ejector and a few decocker springs and trigger bar springs. MUST HAVES.
I tried to order some spare lifter springs a while ago, knowing I would need them, but they've been out. CGW to the rescue.
-
One solution that helps is holding a handgun mostly Inside a large sandwich bag while removing tiny parts.
It can be done while easily viewing the necessary components through the bag's Opening. It will usually block any spring which jumps, in most directions.
And it certainly catches any tiny part which simply falls out.
Thanks for the warning on the lifter spring, but although I've disassembled both a Sig P6' frame and the frame of a S&W 6904 (thanks to superb videos), I have no reason to do any detail strip any CZ frame. :(
-
The lifter spring is so small that you must see it clearly to install the pin and you cannot do the plastic bag technique.
SIGS are MUCH easier to work on compared to the P01 decocker.
-
I use a jewelers lighted magnifier on a stand to do jobs like working on CZ sear cages. The job is so much easier when that little hair spring looks 5 times it's normal size.
-
Agree that having spare parts is a good thing. Having spare CZ pistols is better. :) Then I just send the down pistol to the gunsmith and I am not that worried how long it takes to come back. But I do have a fair collection of small parts so that I can repair my pistols on the range if required. (mainly match guns) and usually because i was trying to do something my pistol was not designed to do.
JW
-
I thought I lost the lifter arm spring during one of my teardown, modify, and assemble sessions. No problem, I followed advice from this great site and had spares. I found the lost spring sticking in my finger when I started looking for the spares. Little hypodermic needle darned spring.
-
i tie dental floss to the spring loop when i put the cage together and leave it there till i install the cage. if you tie a loose loop it is easy to snip and pull out once your done. i also take it apart in a gallon zip lock bag. i have lost the lifter spring twice on the office carpet and found it both times sweeping a 3" circular magnet over the carpet by hand.
-
i tie dental floss to the spring loop when i put the cage together and leave it there till i install the cage. if you tie a loose loop it is easy to snip and pull out once your done. i also take it apart in a gallon zip lock bag. i have lost the lifter spring twice on the office carpet and found it both times sweeping a 3" circular magnet over the carpet by hand.
Great idea.
-
Out of frustration, I just bought half a dozen to have them available any time.
-
Today after some initial frustration I got the thing in there and then went in and out fine and I even pulled the cage out and put the pin back in without messing anything up. You never know when you’re going to have trouble or when things are going to go great,
-
One solution that helps is holding a handgun mostly Inside a large sandwich bag while removing tiny parts.
It can be done while easily viewing the necessary components through the bag's Opening. It will usually block any spring which jumps, in most directions.
This right here, except I use those turkey oven bags since you get more room. Learned this cleaning fishing reels - little springs everywhere!