The Original CZ Forum

GENERAL => CZ Gunsmithing => Topic started by: A. on May 14, 2022, 11:58:57 AM

Title: Slide rubbing the frame (the wrong way)
Post by: A. on May 14, 2022, 11:58:57 AM

I have very lovely PCR from CZ custom shop. Got it brand new. After few range sessions noticed the fresh rubbing marks inside the frame and on the slide.
What would be proper best course of actions?
Thank you!

(https://i.ibb.co/HgJhfWc/PCR-A.jpg)



(https://i.ibb.co/Bf6BSyg/PCR-B.jpg)

Title: Re: Slide rubbing the frame (the wrong way)
Post by: Grendel on May 14, 2022, 01:18:13 PM

Lubricate it and shoot it. The wear will continue until parts are mated to each other then stop.

Title: Re: Slide rubbing the frame (the wrong way)
Post by: SoCal on May 14, 2022, 01:52:03 PM

I would check with CZ Custom and se what they think.

Title: Re: Slide rubbing the frame (the wrong way)
Post by: Lock-n-load on May 14, 2022, 08:37:07 PM

Agree with grendel, also polish everything !

Title: Re: Slide rubbing the frame (the wrong way)
Post by: A. on May 17, 2022, 09:00:32 AM

Shall I speed-up mating process with a file?
If yes, shall I relieve inside of the frame, or the protruding spot on the slide and touch-up?

Title: Re: Slide rubbing the frame (the wrong way)
Post by: MifflinKid on May 18, 2022, 12:54:54 PM

Quote from: Grendel on May 14, 2022, 01:18:13 PM

Lubricate it and shoot it. The wear will continue until parts are mated to each other then stop.

Follow this advice.

No files!