The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Droz23 on August 06, 2022, 05:19:10 PM
-
I had an issue when one round did not eject but a second one from the magazine was fed into the ramp and damaged the tip of the bullet. It was in battery bc I tried to fire it and nothing. I stripped the Mag and I could clear the spend Brass easily by standard racking procedure. Upon inserting the mag I felt the Burr and noticed the issue. I have never seen this before. any Help?
Stock P10c Gen 2 with under 500 rounds.
-
I would leap to a bad round as the issue unless you can repeat it.
Good luck
Sent from my iPad using Tapatalk
-
So, you had a double feed? I had this happen one time only and it was with a P320 Compact 9mm at a Sig Academy course. I cleared it and finished the course of fire. Never had it happen again. I checked out the extractor to see if there was any visible issue, but could see nothing. Check yours, but it could just bee a bad round like mentioned before. If it does keep happening, contact CZ.