The Original CZ Forum

GENERAL => General Discussion => Topic started by: Blackhawk556 on March 08, 2023, 05:11:39 AM

Title: Can’t install left side safety!
Post by: Blackhawk556 on March 08, 2023, 05:11:39 AM
Update: figured out the hammer was stuck back [emoji2357][emoji2357]
An hour later. I think this to me longer than the entire job

I’m installing a cz flat face trigger. I’m having serious issues installing the extended left side safety

I install the right side first but then the left side won’t go in all the way

I removed the right side and was able to push the left side safety all the way through and it operates fine when I move it up and down.

Why is the right side preventing the left from installing?

SP-01

I’m converting it to single action only. I removed the disconnect from hammer


Sent from my iPhone using Tapatalk
Title: Re: Can’t install left side safety!
Post by: Earl Keese on March 08, 2023, 06:34:39 AM
If it's a new safety, it most likely needs to be fitted to the right side. Have you tried putting the safties together outside of the frame?
Title: Re: Can’t install left side safety!
Post by: Blackhawk556 on March 08, 2023, 11:06:22 AM
If it's a new safety, it most likely needs to be fitted to the right side. Have you tried putting the safties together outside of the frame?
The problem was that I had the hammer in the back position and that was causing the issue.  I guess it would not align everything correctly


Sent from my iPad using Tapatalk
Title: Re: Can’t install left side safety!
Post by: M1A4ME on March 08, 2023, 06:29:39 PM
With the hammer back the sear may have been in the way of the safety cam on the left slide safety shaft.

Be sure to check for proper safety operation.  The safety has to be able to stop the sear from moving enough to release the hammer.