The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Clh08 on October 16, 2023, 04:43:41 PM
-
Hi, I am new to the forum and hope I am posting this in the correct place.
I have an issue with my P07 which I noticed while dry firing,when pulling the trigger in DA depending on how much of my finger is on the trigger I get a double clicking sound as I release the trigger the first roughly were the SA would reset and the second the reset for the DA and then when pulling the trigger again the hammer seems to slip causing it not to strike the firing pin. When moving my finger deeper into the trigger guard the weapon functions as normal without any issues. The only mods that I have done was to add the CGW spring kit and oversize trigger trigger bar disconnector as well as polishing the internals as per the MCARBO video.
Has anyone experienced this before as I could not find any similar posts on this ?
Any advice would be much appreciated.
-
Welcome. Please take a few moments to familiarize yourself with all the sticky posts in the 'New Members' section and the other forums, together with the Help Topics in the 'Important Information' or 'FAQ' sub-section.
-
I had a similar issue, although not exactly the same and it was improper tension on the trigger support bar spring. Went through this procedure which resolved it. But that was also not an omega trigger but it may give you a place to start.
https://cdn1.cajungunworks.com/wp-content/uploads/2020/07/28155355/How-To-34-Adjustment.pdf
-
Welcome !
These guns can be quirky right out of the box. You'd need to shoot 500+ rounds and do several cleanings before anything else.