The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: 2Princetons on February 18, 2025, 01:38:15 PM
-
Here's the one for the CZ P10's...
https://www.amazon.com/dp/B0DL8NTT4M?ref=emc_s_m_5_i_atc
-
I've only bought/used them on the M&P pistols.
Zero issues with them.
-
Thanks, M1A4ME! I guess I can't go wrong with Amazon's return policy.
-
That's true.
I bought one I haven't had to use yet. My M&P 2.0 .40 PC pistol came with those plastic adapter plates. Many people complain about them. I used mine (no issues so far after more than year) but bought a DPP plate as a backup in case the plastic plate did cause problems.
Glad to see CZ finally starting to put out OR models, but I've already had my P07 .40 and P09 9MM slides milled for dot optics and back up iron sights years ago.
-
I have their rmr plate on my P10F with a 507 comp. Only had it for about 750 rounds but so far no complaints. Its also a tiny bit thinner than the CZ plate.
-
Well, I ordered the $40 DPP plate for my P10F from Amazon. It comes in a nice package with multiple sets of screws for the plate itself and the Holosun 407C I mounted. I used the DPP screws rather than the ones that came with the Holosun for the red dot-to-plate.
I saw a (Reddit?) thread where the poster had a P10F that he buggered the optic plate cover screws trying to remove them. He said that CZ used red Loctite on the cover screws from the factory. The ones on my P10F where held in with some sort of white thread locker...the screws came out with little trouble.
The DDP screws come pre-coated with blue Loctite...that made them pretty snug as I fastened the plate to the slide. My Fixit-Stick was showing >10in/lbs just running the screws down. I stopped, removed the screws and added a drop of (wet) blue Loctite. After that they went it more easily. There appears to be ample thread engagement for the Holosun-to-plate screws as well, and the gun functions fine using the DPP screws from the packet marked HOLOS.
I just got back from the range...my first shot was 1.5" low & centered. 3 or 4 shots later I was done tweaking the Holosun. As a bonus...I can just "co-witness" the factory iron sights at the bottom of the Holosun's window.
I'm feeling better about my P10F now. My understanding is that the P10S & C are zero'd for 15 meters, and the P10F is zero'd for 25 meters using a combat hold. I was consistently shooting ~1.5-2.0" low at 7 yards with the factory sights with a center hold. If I aimed 2" high the sights were pretty much covering the 2" target stickers I use. Today the holes were appearing right where I put the dot, give or take a smidge.
My only problem now is I have to wait until tomorrow to shoot it some more.