The Original CZ Forum
CZ PISTOL CLUBS => CZ SP-01 and variants => Topic started by: viking499 on April 08, 2025, 11:00:41 AM
-
Where do you recommend I get an optic plate for my S2C that will accept a Holosun 507C footprint?
-
Correct me if I'm wrong but isn't the s2 compact the same as the full size and the 507c is on a rmr footprint? If so then I recommend Athena. I had chpws aluminum for both my p10c and F. Did not like them at all. Always came loose and the screws always stripped. I use loctite and a torque wrench.
Athena plates are steel and use better quality screws. The plates also had my rmr sitting lower and better fit. No hang over.
https://athenaprecision.com/products/cz-shadow-trijicon-rmr-steel-red-dot-adapter-plate
A pop up might come up to save some money or free shipping.
-
I put the DPP titanium plate on my P10f, cheap and thin. Have about 2000 rounds of competition shooting on it with no issues. FYI I used their screws to mount the plate to the pistol (I cleaned them and applied blue loctite) and the Holosun screws to mount the optic to the plate.
https://www.amazon.com/DPP-Titanium-Compatible-Trijicon-SRO-CZ-SDW-02/dp/B0DTJSNKPV?ref_=ast_sto_dp
-
I put the DPP titanium plate on my P10f, cheap and thin. Have about 2000 rounds of competition shooting on it with no issues. FYI I used their screws to mount the plate to the pistol (I cleaned them and applied blue loctite) and the Holosun screws to mount the optic to the plate.
https://www.amazon.com/DPP-Titanium-Compatible-Trijicon-SRO-CZ-SDW-02/dp/B0DTJSNKPV?ref_=ast_sto_dp
Forgot about the dpp. I have a friend that uses them and never had an issue. At the time the P10 plates were out of stock.
If you don't go with Athena I'd def give the dpp a try.
-
I purchased an optic plate with BUIS from CGW to mount my Trijicon RCR on my S2C. The BUIS co-witness very well with the existing front sight. I haven’t had any issues.