The Original CZ Forum

GENERAL => CZ Custom => Topic started by: DrDremel on January 05, 2006, 10:32:05 AM

Title: Extended or threaded barrel?
Post by: DrDremel on January 05, 2006, 10:32:05 AM

My state just became silencer friendly and now I am looking at my options.  Does anybody know where I could get an SP01 barrel that is extended and threaded?  Would it be possible to get the IPSC barrel and get it threaded?  I also would like to get one for a CZ75B and a kadet.  If these barrels are not available does anybody extend and thread a barrel?  I dont know if this can be done without screwing up a barrel.  Thanks for the help.

Title: Extended or threaded barrel?
Post by: Stuart on January 05, 2006, 05:08:26 PM

Might try talking with Bob Hostettler at BarSto..

their barrel is made long to be cut..it may have the right OD to fit the SP01..

anyway..a place to start..

Title: Extended or threaded barrel?
Post by: angus hobdell on January 06, 2006, 10:35:10 AM

SP01 might be a problem.
It has the outside Dia of the TS barrel but the locking lug of the ts is different from the SP01. So SP01 has odd barrel, barstow for a custom barrel might be the only way. Unless we can get CZ to make the extended barrel that the australians need for there new 120mm law.