The Original CZ Forum
CZ PISTOL CLUBS => CZ SP-01 and variants => Topic started by: ScottJ99 on May 14, 2009, 01:46:54 PM
-
After much reasearch, I made the decision and bought a SP-01 from CZ Custom. I received it Tuesday and proceeded to put 100 rounds down range. Here is my question/Concern:
I had approx. 7-8 stovepipes in the first 100 rounds. I realize there is a break in period, but at what point should I consider the gun broken in? At that point, what do I need to do to eliminate the FTE's. I am pretty sure I did not limp wrist any of the shots. Any advice would be greatly aprreciated.
-
I usually shoot about 500rnds looking for issues..
usually I'll run a gun in competition or carry if I get 300-400 rounds trouble free.
what ammo are you shooting?? FTE-eject? or extract?
-
I have had a few failures to feed in my first few hundred rounds with my SP-01 tactical. All of them have been with the same type of ammo so I am hoping that is the only issue. If it is a consistent problem, I am going to be very concerned.
-
I have an SP-01 Tactical and am still breaking it in. Also with some failure to feed problems but I will stick through the break in period and see what happens.
-
Interesting that you have had problems as well. I really hope that this is not a significant reliability issue. I know there is a sticky about things you can do to minimize problems with the SP-01 but I have a hard time buying the idea that I should have to modify a brand new gun to make it reliable. If this continues, I am unfortunately going to have to seriously consider buying something else.
-
Don't worry, my shadow had a handful of FTFs and stovepipes in the first 300 rounds. Since then I haven't had a stovepipe or FTF in the next 1000 rounds. I polished the feed ramp with 000 steelwool and that cured the FTF.
-
eerw,
I used 115gr. FMJ (American Eagle? - not sure of the brand). Not sure what the difference between eject and extract is, I would guess eject, the failures were stovepipes, as a result of the spent casing not ejecting, the next round would not feed properly.
-
I have run the AE115s with good results..
stovepipes would be a failure to eject. if the case was being left in the chamber and the extractor not grabbing it, that would be a failure to extract.
since a stovepipe you recoil spring may be too heavy or just need to take a set.
-
eerw,
Thanks for the info. I think I will continue to monitor for 300-400 more rounds, if I still have a problem, I will change out the recoil spring for a lighter one. What do you recommend? I will be using for target practice, HD as a secondary purpose, and maybe further down the road some IDPA.
-
I run 11# spring in my CZs for my USPSA/IDPA loads and factory ammo. I run a 12# or 14# spring for +P ammo
-
All info is appreciated. This is not my first SP-01. I need to run more ammo through it. Not enough break- in time. Also shot the SP-01 as soon as I got it. Really needs to go to the range after a good cleaning.
Thanks.
-
I'd never shoot a CZ pistol without taking it completely apart for a thorough cleaning. They cake those suckers with so much grease that once hot powder hits them it seazes like crazy.
-
Those stovepipes must be very frustrating. Scott does not appear to be the only one whose SP-01 has teething problems.
I wonder if perhaps CZ's spring supplier(s) has trouble making recoil springs of consistent "weight" ?
-
I know I should have cleaned it first, but I was anxious to try it out. Not the best choice in hind sight.