The Original CZ Forum

CZ PISTOL CLUBS => CZ CLONE CLUB => Topic started by: MarvtheGrate on May 27, 2009, 10:54:58 PM

Title: EAA Witness trigger pin problem
Post by: MarvtheGrate on May 27, 2009, 10:54:58 PM

I've an EAA Witness - P .45 that has a problem with the hinge pin for the trigger drifting out when used.  I am wondering if anyone else has seen this problem. 
Thanks in advance.

Title: Re: EAA Witness trigger pin problem
Post by: Tanfoglio on May 27, 2009, 11:22:28 PM

Yes, both of my 9mm's have the same problem. 

I just staked it with a pin punch and all is well now.

 

Fred

Title: Re: EAA Witness trigger pin problem
Post by: MarvtheGrate on May 27, 2009, 11:28:11 PM

Thanks, I will give that a go.  I like the Witness, and it's my only .45, but it's clear that fit and finish just are not to par with my other CZs.

Title: Re: EAA Witness trigger pin problem
Post by: jwc007 on May 28, 2009, 12:34:41 AM

If that does not cure this problem, just get a new Roll Pin of the appropriate size and replace it.  Just use the shanks of a Drill Bit Set to determine the right size.  A Real Hardware Store and/or Industrial Supply will have them.  Install with the appropriate sized Roll Pin Punch.

Title: Re: EAA Witness trigger pin problem
Post by: MarvtheGrate on May 28, 2009, 01:22:37 PM

Thank you for the advice.  I will look in to that the next time I shoot it.  I like the .45 and I really like that it has the same feel and operation as my CZs.  I've just been drifting the pin back in each time I take it out.  I will try staking it first to see if that will solve the issue.