The Original CZ Forum

GENERAL => CZ Gunsmithing => Topic started by: oldfrank on October 20, 2013, 01:21:47 PM

Title: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 01:21:47 PM
I installed the drop in CGW disconnect on my CZ 85. Everything seems to work fine unless I hold the trigger back,cycle the slide and attempt to pull the trigger again.

I have to rock the hammer back ever so slightly and the trigger will then work normally. I want to be able to fire from reset if I am going to try to shoot this in a match.

Can anyone shed some light on this?  I plan on calling the shop tomorrow but if this is a common problem with a quick fix I would like to fix it today and go to the range tomorrow.

Thanks!

Title: Re: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 01:41:52 PM
UH Oh :( I think I falsely blamed the disconnect and it is not the disco.

I also replaced the safety with a brand new one and I checked all the safety functions and they all worked, I did not check to see if the trigger would reset after being held back as I did not see the safety affecting this but apparently it does.
Title: Re: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 03:30:47 PM
Dang, if I keep talking to myself and studying the gun I think I got it fixed. :)

I swapped safeties two or three times and sometimes one worked and sometimes it didn't and vice versa. The problem starting coming and going until I noticed the trigger pivot pin was sticking out about 1/8". :o

I pushed it back in and so far everything works fine with either safety installed.

I am going to the range tomorrow, that will be the true test.
Title: Re: Help with CGW Disconnect
Post by: 1SOW on October 20, 2013, 05:16:00 PM
I know the 'feeling'.
What trigger pin are you using?  Stock? CGW solid pin? CZC solid pin?
Title: Re: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 05:19:03 PM
Stock I assume. It is hollow and flared on at least one end.

Sent from my Droid Razr

Title: Re: Help with CGW Disconnect
Post by: 1SOW on October 20, 2013, 05:46:39 PM
That's stock and can be a minor PITA to remove and reinstall.
You would be very happy with either the CGW or the CZC solid firing pins that are very easy to remove/install and won't back out.  They are well worth the minor cost.
Title: Re: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 06:11:53 PM
Thanks, I am still new to the CZ platform and there is much to learn.
I will look into something new pin.
Thanks

Sent from my Droid Razr

Title: Re: Help with CGW Disconnect
Post by: laserdoc on October 20, 2013, 08:39:16 PM
Hey frank,
Did you shoot this month at Cherokee Idpa?
Title: Re: Help with CGW Disconnect
Post by: oldfrank on October 20, 2013, 08:53:27 PM
No,Grand Son turned 4.

Sent from my Droid Razr