The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Magsz on April 13, 2014, 07:11:29 AM
-
Has anyone milled their P09 for an adjustable sight like an LPA or a Bomar?
Im wondering if there is enough meat up there to make this possible?
-
If I recall right you can use standard 75 adjustibles. But don't see why you couldn't get them milled to lpa. I really like Cz custom fibre optic cOmbat set up there close and with file and brass punch its a tack driver. I shot my four staples off target yesterday with less then a mag. At 15 ft. The last adjustibles I had were on a Kimber eclipse target. I liked them but can acquire target better with this setup w green fibre. I think it shouldn't be a problem milling the slide but smecky and Stuart on here should both be able to help you with depth measurements if you are doing it on a mill. They both may have a set for you without milling. Cajun gun work and Cz customs.
-
Good question. I want to install a 10-8 rear on the P07 after I pick one up in a month or so which means a Novak cut. Why? Because I much prefer a plain black rear with a U-notch and a Dawson Precision fiber optic front sight or an XS tritium on my guns. Personal preference I suppose.