The Original CZ Forum

GENERAL => CZ Gunsmithing => Topic started by: jimsjrt on June 14, 2016, 08:30:47 AM

Title: What tools and parts to have available?
Post by: jimsjrt on June 14, 2016, 08:30:47 AM

New to the CZ club, coming from the Glock club. With my Glocks all I needed was a Glock tool or nail to disassemble the gun. I always have enough springs and connectors on hand. Now that I have a P-07, and P-01, with Omega triggers just wondering what to keep on hand?

Title: Re: What tools and parts to have available?
Post by: Mike87 on June 14, 2016, 08:56:59 AM

I'm interested as well. I too have a P07 and would like to know what is recommended to keep on hand as far as tools (brands too please) and parts. I would like to do some CGW upgrades eventually but I'm not sure what punch sets and such I should buy.

Title: Re: What tools and parts to have available?
Post by: Chow89 on June 14, 2016, 01:14:23 PM

Here's my list of tools for my omega based pistol. (P09)

Set of punches (brass is probably best but the ones I use are steel)
Decent Hammer

That's it. The omega was built to be easy to work on as an armoror.

I do use a pick to seat the decocker spring cause I can't get it to hook when installing the lever, so I install the lever and then use the pick to pull the spring until it engages the hook on the lever.

I also use an delrin rod that's 1/2" ODx 9" long that I made from some scrap I have, when removing or installing sights to prevent damage to the sight or slide.