The Original CZ Forum

CZ PISTOL CLUBS => Compact CZ 75s => Topic started by: bgriff008 on July 18, 2016, 07:05:48 PM

Title: Decocker sear slave pin length? Anyone know the length so I can make my own.
Post by: bgriff008 on July 18, 2016, 07:05:48 PM

I'm cutting down an old drill bit to use as a decocker sear slave pin. I need to remove the sear controls intact to bead blast my frame for cerakote. So the length of the slave pin is needed. Thanks.

Title: Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
Post by: bgriff008 on July 18, 2016, 08:39:43 PM

Disregard. I just ordered the slave pin with start punch and some other upgrades from CGW, including spring kit and floating trigger pin.

Title: Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
Post by: Obiwan on July 18, 2016, 11:01:23 PM

If it's only temporary, why not use the hammer spring retention pin? (the one at the bottom at the grip). Has the perfect length.

Alternatively, a piece of q-tip will work.

Title: Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
Post by: bgriff008 on July 19, 2016, 08:20:13 AM

bleep. Thanks. I ordered it and the punch from CGW. But good to know. Yes it will be temporary. I'm disassembling the gun to cerakote it. I'm doing the frame first then the slide.

Title: Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
Post by: schmeky on July 19, 2016, 10:01:43 AM

Straight from our instructions:

The slave pin should be approximately .106? OD x .680" long with a radius on one end