The Original CZ Forum

CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Thebillsman on June 21, 2017, 09:06:23 PM

Title: Lubricating the P-10C
Post by: Thebillsman on June 21, 2017, 09:06:23 PM

How do you guys plan on lubricating your pistol?

I've been going by glock recommendations with a drop of oil down each slide rail and a drop over the trigger connector in the rear. I'm seeing wear marks on the slide locking block and the trigger mechanism housing that could use a little grease.

Title: Re: Lubricating the P-10C
Post by: DOC 1500 on June 21, 2017, 09:57:07 PM

Just get some REM oil and spray it once in awhile that's all.  just keep it lubed , keep it oiled.
A lot of guys use Mobil 1 motor oil.

Title: Re: Lubricating the P-10C
Post by: eastman on June 21, 2017, 10:44:48 PM

CLP on the rails and barrel. A small extra drop of CLP on any shiny spots.

(I'm currently using Breakfree CLP on my P-10c, although I used OTIS O-85 CLP on the pre-release loaner P-10c)

Title: Re: Lubricating the P-10C
Post by: Joe L on June 22, 2017, 07:12:52 AM

Same as the rest of my pistols in the summer, a little Slide Glide Lite on the rails and barrel and at the contact point of the striker and trigger bar, a little oil in the frame parts.  Clean the chamber and ramp thoroughly along with the breech face every 500-1000 rounds and a few patches down the barrel.  Clean the magazines every month or so. 

Joe