The Original CZ Forum

CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: Stopsign32v on June 22, 2017, 08:59:06 AM

Title: What would cause the decocker lever to sag or feel like no spring?
Post by: Stopsign32v on June 22, 2017, 08:59:06 AM: Got a used P07, 2014 make, and the decocker is acting funny. Hammer down its tight and feels normal. If the hammer is cocked and you go to decock it, it works, but the decocker lever does not return back parallel with the slide like it should. It stays in the lowered position to where you can see the safety red dot on the frame. Push it back up manually and you are back to normal.

My other P07 has a nice strong spring reset after the decocker is activated.

Any ideas?
Title: Re: What would cause the decocker lever to sag or feel like no spring?
Post by: Winkel on June 22, 2017, 01:56:14 PM: Check that the end of the decocker spring is under the tab on the decocker shaft.
Title: Re: What would cause the decocker lever to sag or feel like no spring?
Post by: Stopsign32v on June 22, 2017, 05:37:03 PM: Quote from: Winkel on June 22, 2017, 01:56:14 PM
Check that the end of the decocker spring is under the tab on the decocker shaft.

That was it, previous owner did not install it correctly. Thank you
Title: Re: What would cause the decocker lever to sag or feel like no spring?
Post by: Joe L on June 22, 2017, 05:49:03 PM: Quote from: Stopsign32v on June 22, 2017, 05:37:03 PM
Quote from: Winkel on June 22, 2017, 01:56:14 PM
Check that the end of the decocker spring is under the tab on the decocker shaft.

That was it, previous owner did not install it correctly. Thank you

I've done that. :) :)
Glad you got it fixed.
Joe
Title: Re: What would cause the decocker lever to sag or feel like no spring?
Post by: CZ Aficionado on June 22, 2017, 06:04:33 PM: Quote from: Winkel on June 22, 2017, 01:56:14 PM
Check that the end of the decocker spring is under the tab on the decocker shaft.

First thing I was going to suggest.......glad you got it worked out :)