The Original CZ Forum

CZ PISTOL CLUBS => CZ 2075 RAMI CLUB => Topic started by: unionman on January 03, 2018, 07:57:05 PM

Title: CZ Rami "sticky" mag question
Post by: unionman on January 03, 2018, 07:57:05 PM: I recently picked up a CZ Rami BD, 9mm, really like it a lot. However, the mags are fairly "sticky"; i.e. I need to jam them hard to get them to seat and they usually won't "drop free" because of this. Same with multiple mags, but some are worse than the others. Is this a normal thing with the Rami? Will it better with time? Any way to fix? thanks!
Title: Re: CZ Rami "sticky" mag question
Post by: Pierce on January 03, 2018, 10:21:59 PM: Look into the mag well and see if the grip screws or bushings are protruding in to the mag well.
Title: Re: CZ Rami "sticky" mag question
Post by: cntrydawwwg on January 03, 2018, 11:08:05 PM: Quote from: Pierce on January 03, 2018, 10:21:59 PM
Look into the mag well and see if the grip screws or bushings are protruding in to the mag well.
More than likely, this right here is the issue.
Title: Re: CZ Rami "sticky" mag question
Post by: unionman on January 04, 2018, 01:27:46 AM: Will check that out, thanks!
Title: Re: CZ Rami "sticky" mag question
Post by: cntrydawwwg on January 04, 2018, 08:57:32 AM: It doesn?t take much. I?ve had this happen when a bushing was turned in half a turn too much.
Title: Re: CZ Rami "sticky" mag question
Post by: unionman on January 05, 2018, 04:40:18 PM: That was the ticket, thanks!
Title: Re: CZ Rami "sticky" mag question
Post by: jack76590 on January 17, 2018, 09:23:12 AM: I had same problem. While bushings will not move with grips in place, I still decided to loctite bushings. Use blue loctite so if need to remove should be no problem even without heat, but if needed no problem to apply a little heat in that area.