The Original CZ Forum

GENERAL => CZ Gunsmithing => Topic started by: Bigspur84 on February 16, 2018, 04:31:48 PM

Title: P-10 backstrap
Post by: Bigspur84 on February 16, 2018, 04:31:48 PM

Hello,
My new P-10 is arriving tomorrow and I wanted to know what punch tool you needed to replace the backstrap? Also if I need to take the gun apart for like replacing the trigger, what kind and size punches do I need?  Thank you for the help

Title: Re: P-10 backstrap
Post by: 2morechains on February 16, 2018, 05:58:06 PM

https://m.youtube.com/watch?v=eUdPCtK1Zxo

Title: Re: P-10 backstrap
Post by: cremaley on February 19, 2018, 09:05:44 AM

I've heard that removing the pin to replace the backstrap is very difficult. Any truth to this?

Title: Re: P-10 backstrap
Post by: Rickytick on February 19, 2018, 09:44:44 AM

Its a total pain. I took mine to a gunsmith to punch it out (did not charge me) so i could try all the back straps. After deciding to keep the small one I had him install the HB trigger and put the pin back. I emailed CZ to get a 2018 catalog and give me the pin size, no reply. I did garbage up one end of the pin trying to get it out myself. I needed to try all sizes before ordering talon grips.