The Original CZ Forum
CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: StealthyTX on February 18, 2018, 01:32:32 PM
-
Despite what I had read about issues with the P10c, especially reports of "trigger bite" I went ahead and got one. I got the black threaded barrel version, serial begins with C431XXX, and the test target is dated 11-30-2017. I was going to get the regular version, but I got is one for $520, and my other choice was a standard FDE for $505. Since I have an Omega 9K in jail, it seemed like a no-brainer to pay the extra $15 for a threaded barrel and suppressor height sights.
Fired it for the first time today, and it is quite accurate. After reading reports of the trigger, I was afraid that I would end up with a blister on my finger the way I did with a PCR stock trigger a couple years ago. That didn't happen this time, but I did only fire 3 mags, because it quickly became apparent that while the trigger didn't beat up my finger the way the PCR did, it did quickly become uncomfortable to shoot. All things considered, I think after I replace the trigger with an HB or Cajun, it will be a keeper.
Other little things I like: a bit of stippling on the frame that tells me where to put my thumb, and that mags from my P-07 seem to be identical and work just fine. Time to start looking for a suitable holster, and trying to find a good way to make sure the thread protector stays on while firing (just took it off at the range for now).
-
I feel that once you replace the factory trigger with either an HBI or CGW flat trigger you will be extremely happy with your P-10. I've owned threaded barrel models before and it alway been a pain in the butt keep the protection cap in place while shooting. You don't want to Loctite it because the barrel needs to be removed for cleaning the gun. I use to tighten the cap with a pair of pliers or most times remove it and put it in my pocket until I was finished shooting. Either way its a pain in the butt.
-
Put on a rubber "O" ring before your threat protector and it will stay in place just fine.
Best regards.
-
Put on a rubber "O" ring before your threat protector and it will stay in place just fine.
Best regards.
That sounds like a great idea. Wish I had though of that.
-
I actually tried the o-ring thing on my P-07, maybe I put it on wrong but it didn't seem to work.
I did some searching and found these tonight, and ordered a couple, hopefully they work:
https://www.store.silencerco.com/products/thread-protector-with-o-ring-engagement?avad=55963_c111945cd&variant=221756558
-
I have the sico protector, it works great but a cheap o ring works great too.
I have an hb trigger but I also took an exacto knife to my stock strigger removing the excess of the dingus or blade whatever u prefer to call it, and it?s actually really comfortable.
Sent from my iPhone using Tapatalk
-
At a cost of only $16 I would definitely give it a shot.