The Original CZ Forum

GENERAL => Cajun Gun Works => Topic started by: CZDad on February 18, 2018, 04:21:10 PM

Title: SRS 1 install question on a PCR
Post by: CZDad on February 18, 2018, 04:21:10 PM
I have started to do the install work of a CGW SRS-1. This is on a PCR.   The directions seem easy enough, and I got started eagerly. 

I'm getting ready to remove the sear cage pin. When I notice that on the left side the frame.  It doesn't look big enough for the pin to be removed.

(https://i.imgur.com/oAOIoKV.jpg)

All the other pictures of this process I've seen does not have this.  It's just a pin to be driven out.  Am I missing something?


Thanks!

-CZDad
Title: SRS 1 install question on a PCR
Post by: cntrydawwwg on February 18, 2018, 05:05:48 PM
It?s a disk to help hold the sear pin in. ( actual part is called ?fixing insert?) Place a punch on the edge of the inner hole and tap it out. Make sure to put it back in when putting back together. Should slide back in, sometimes I use a punch and push it in.
Title: Re: SRS 1 install question on a PCR
Post by: CZDad on February 18, 2018, 05:08:20 PM
Awesome Thanks! @cntrydawwwg
Title: Re: SRS 1 install question on a PCR
Post by: cntrydawwwg on February 18, 2018, 05:09:17 PM
Most welcome.