The Original CZ Forum

CZ PISTOL CLUBS => CZ SP-01 and variants => Topic started by: sumoman on March 28, 2018, 06:17:35 PM

Title: Pins on 2017 Phantom getting out after shooting
Post by: sumoman on March 28, 2018, 06:17:35 PM
I have a 2017 Phantom, where I had Cajun short reach trigger kit installed by a qualified gunsmith. I notice that two pins right above the trigger (trigger pin and sear spring pin, I guess they are called) reptate out when I shoot 50 rds or more. Probably half of each pin sticks out of the frame and I have to gently hammer them back in. I suppose if I shoot more without hammering them, they would completely get out of the frame and the pistol will fall apart.
 :-[
I wonder if there is a remedy for this. Is it hard to get new pins from CZ? I noticed that pins did not get out before the CGW trigger kit was installed.
TIA