The Original CZ Forum

CZ PISTOL CLUBS => CZ Polymer Pistols: P10, P-07, P-09 => Topic started by: derek_king on July 28, 2018, 02:56:48 PM

Title: Please need help with CZ P07
Post by: derek_king on July 28, 2018, 02:56:48 PM

Hello!
Can someone measure exact diameter of hole for barrel at slide CZ P07? I will be very grateful! Thanks!

(https://i.imgur.com/Ohjb5pL.jpg)

Title: Re: Please need help with CZ P07
Post by: snakeye on July 28, 2018, 11:20:27 PM

I take it you mean the 9mm

12-6 oclock  .570
3-9 oclock  .570

Title: Re: Please need help with CZ P07
Post by: derek_king on July 29, 2018, 03:40:06 PM

Quote from: snakeye on July 28, 2018, 11:20:27 PM

I take it you mean the 9mm

12-6 oclock  .570
3-9 oclock  .570

Many thanks!!!

Question: What if the diameter is .610 ... What problems can be while shooting except accuracy?

(https://i.imgur.com/VhuNdEB.jpg)

Title: Re: Please need help with CZ P07
Post by: SI VIS PACEM PARRABELLUM on July 29, 2018, 04:47:01 PM

No problem at all. There will be variations in the tolerance here. The question is how does the gun shoot? High? Low? Right on? You will notice the number 3 on your front sight. Different number sights are available to adjust for elevation?
Once again are you having an accuracy issue?

Title: Re: Please need help with CZ P07
Post by: MHSOwner on July 30, 2018, 05:10:34 AM

If your red sighting line is trying to explain something, it isn't drawn correctly.
Sight alignment should be top of front sight and top of rear sight.

Title: Re: Please need help with CZ P07
Post by: MHSOwner on July 30, 2018, 05:13:06 AM

Also, sights take into account the recoil of the gun while the bullet is still traveling in the bbl.
The proof is in the shooting. Have you shot this yet?