The Original CZ Forum

CZ PISTOL CLUBS => CZ 2075 RAMI CLUB => Topic started by: charlestheforth on January 16, 2019, 01:48:52 AM

Title: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: charlestheforth on January 16, 2019, 01:48:52 AM
I have always wondered why there arent any ultra thin grip options for most alloy guns.  Its about an 1/8 inch thinner, which doesnt seem like a ton but this difference is literally what the entire craze of the p365 has been about.

has anyone carried their gun without grips?
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: Tok36 on January 16, 2019, 02:24:10 AM
Why not just make some duct tape grips. :D
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: mecenas on January 16, 2019, 09:59:34 AM
The only problem with any king of tape is that it could obstruct free movement of the magazine. The windows in the frame would allow the tape to come in contact with the tape -with easy to predict results.
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: holidaypf on January 16, 2019, 10:37:05 AM
One of these days, I'm going to take a crack at making my own grips. Maybe with some Texas cedar.
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: Tok36 on January 16, 2019, 10:57:43 AM
Quote from: mecenas on January 16, 2019, 09:59:34 AM
The only problem with any king of tape is that it could obstruct free movement of the magazine. The windows in the frame would allow the tape to come in contact with the tape -with easy to predict results.

Well that is why you slick the inside of the tape with bacon grease. As a bonus, when you shoot it smells like bacon.  ;D
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: MeatAxe on January 16, 2019, 07:37:29 PM
Quote from: charlestheforth on January 16, 2019, 01:48:52 AM
I have always wondered why there arent any ultra thin grip options for most alloy guns.  Its about an 1/8 inch thinner, which doesnt seem like a ton but this difference is literally what the entire craze of the p365 has been about.

has anyone carried their gun without grips?

If that's the case, CZ should commission Pachmayr to make their ultra-thin G10 grip panels for the Rami.
Title: Re: the Rami with its rubber grips removed is virtually the same width as the p365
Post by: frogwalking on February 17, 2019, 02:24:23 PM
Seriously; one can buy G1o sheet cut to size from several plastic manufactures or retailers on-line.   I haven't had the grips off my RAMI since the grip screws fell out.  If the grip panels are flat on back, it should be a cinch to make what you are proposing.  If they aren't flat, maybe you cam cut them out with a router.  One can buy thin flat pieces of exotic woods from https://www.woodcraft.com/?gclid=EAIaIQobChMIoKrd6L3D4AIVqSCtBh2ZTgqYEAAYASAAEgL8e_D_BwE
If you want them thinner, sand them down.  I once bought some very thin walnut plywood on-line several years ago for a music box.  Look it up.  Try it.