The Original CZ Forum
GENERAL => CZ Gunsmithing => Topic started by: Cujo99 on September 10, 2019, 06:00:29 PM
-
SP-01 tactical,
Installed a CGW 75200 defense carry kit including short reset FPB lifter and longer firing pin that goes with the short reset parts.
With the trigger held all the way back then a short slide movement (basically just moved back until the take-down marks line up). I then get a very very short hammer drop if I release the trigger to the reset point then pull trigger.
OK, after further investigation it seems normal as it appears that moving the slide to the take-down marks is just far enough to move the hammer so that the sear drops into the half cock notch.
Then re-setting the trigger allows the trigger bar to move the sear far enough to lift it out of the half cock notch & drop the hammer (I didn't realize a trigger pull could drop the hammer from the half cock notch) as it is usually in double action once the trigger is fully released.
Doesn't seem like it would be a problem, just something that seemed odd to me at the time.