The Original CZ Forum

GENERAL => Lights, Lasers and Red Dots => Topic started by: ARP on February 28, 2021, 04:38:05 PM

Title: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: ARP on February 28, 2021, 04:38:05 PM
Self explained title, I have a P-10C OR and I might want to get my P-09 milled. Also any good or bad points would be helpful. I am thinking of keeping the rear sight where it is and using a Vortex Venom rds.
Title: Re: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: gombey on February 28, 2021, 04:52:57 PM
I’m going to use this company:

https://jagerwerks.com/cz/optic-cuts/
Title: Re: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: ARP on February 28, 2021, 05:59:27 PM
I might have to contact them, I plan to use a Vortex Venom, I see Vortex is not mentioned as an option. I might need to find out why not or associated problems with a Vortex mount.

I go with Vortex due to their warranty.
Title: Re: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: gombey on February 28, 2021, 09:41:33 PM
My mistake. I didn’t read your choice of optic.

This was another company I though about using until I found Jager Werks:

https://primarymachine.com/cz-optic-milling/
Title: Re: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: larryflew on March 01, 2021, 12:52:41 AM
All are within a couple bucks (typical total around $180). CZCustom and Cajun Gun Works included.
Title: Re: I am looking to get my P-09 milled for a RDS, recommend a biz to do this
Post by: M1A4ME on March 01, 2021, 06:59:29 AM
I sent my slides (3 of them) to Primary Machine several years ago. 

Good prices, good communication, good work and I'm still shooting them.