Hi there
I'm a new Scorpion owner and taken it to the range twice so far. First time was to get a feel for it but noticed it was shooting 124s low. Second visit brought several different weighted ammo (115, 124, 147) from various manufactures to see if there was one in particular that it liked more than others -but- had the same results. The Scorpion has a 16" barrel and KVP linear Comp on it now. One thing I noticed is - when adjusting the front sight post it will not go down more than flush with main housing - meaning the tappered base of the front post is flat with the center section on the housing. I would think when rotating the front sight post to lower it, the post would recess somewhat in the main sight housing. Right now I feel like my front sight post only has the ability to go up. All my shots are about 3" to 4" low at 25ft with various ammo types. The groupings are nice and tight lining up with the front sight post just too low for my liking. I have a red dot to install but want to get the irons zero'd before adding another variable into the mix.
Should I remove the entire front sight assembly and see if the post or detent is catching on something preventing the post from going any lower?
Any advice would be greatly appreciated.
Thanks