Very cool.
I'm trying to figure out what you did.
1. Barrel threaded for a comp
2. Shortened the slide to keep the length of the gun down
3. Opened up the frame to make room for the comp
4. Drilled the frame for the gas pedal
5. Put on a larger magwell
6. Added grip tape
7. Coated the frame
8. New grips
Anything else?
It looks like an awesome project.
How did you make sure the barrel threading was concentric?
Did you have to fit the comp to the slide? It looks like it acts as the barrel bushing
1.barrel threaded
2.shortened slide to fit comp in ready position of gun,so i cut 1cm then using dremel tool to grind more and more to perfect fit
3.no,i just get out bushing then make conus (make inside slide angle,i dont know how to explain in English) for compensator to fit perfect,then is no need for bushing
4.drilled frame for optics mount and gas pedal
5.putted aluminum larger magwell
6.grip tape was last,i like it.i use lot of sandpaper on frame to get thin grip and make it more like CZ CM,becouse diference is large in frames between TS and TSO and CM
7.coated frame and slide
8.yes,new aluminium grips
9.inside,CM spring and guiderod,recoil spring housing,ultimate trigger spring,ultimate other springs,alu trigger.
