Oh, and if anyone can give me a hint about taking apart the mags for cleaning, I'd appreciate the tips. Otherwise, I'll try to figure it out and post what I find.
Without seeing / knowing what the bottom of the Base looks like, I wouldn't be sure
But (afaIk), some of those Ploy Mags come apart, as most any of your Steel Body Mag would
There's usually a Hole in the Base to depress Locking Plate (It may be hard to see it inside that void
Then the Base "should" slide forward
Being everything's Polymer, it may be a bit tight, and need some "encouragement"
If that's not the case, then there's the type with a solid, one piece Body construction
These you need to take it apart from the Top, through the Feedlips (It helps if you have a single Chopstick handy for this)
There are two Pins that need to be removed
One is the Thumb Assist Pin for the Follower
This is removed by sliding the Thumb Assist all the way down to that round opening at the bottom of its travel
Then press that Thumb Assist Pin, out, from one side or the other
That Chopstick works great to hold and control your Follower
The Follower (and maybe the Spring) should come (and if not controlled .... FLYING) out through the Feedlips
The other is the Pin down towards the Bottom
This holds the Spring Plug in place
It should just slide right out, now that there isn't any Spring Pressure holding it
Reassembly is just the reverse
That's where you'll really need that Chopstick
Good luck .... remember .... Eye Protection
