« previous next »
Pages: [1]   Go Down

Author Topic: Post on mods to extractor ?  (Read 1488 times)

0 Members and 1 Guest are viewing this topic.

Offline kabong57

  • Full Member
  • ***
  • Posts: 139
Post on mods to extractor ?
« on: July 20, 2021, 01:09:01 PM »
Doing a search and saw mention of bending the extractor. Is there a link to a post with details ?
Logged

Offline Joe L

  • Hero Member
  • *****
  • Posts: 7361
Re: Post on mods to extractor ?
« Reply #1 on: July 20, 2021, 01:34:08 PM »
I don't remember anything on bending a Kadet extractor, probably because the extractor is very brittle and will break if you try to bend it.  I do remember a few posts about modifying the extractor tip with a file to change the direction the case ejects.  I think.  It's been a few years ago, however. 
Joe
Logged
CZ-75B 9mm and Kadet, 97B"E", two P-09's, P-07, P-10C, P-10F, P-10S, MTR

Offline kabong57

  • Full Member
  • ***
  • Posts: 139
Re: Post on mods to extractor ?
« Reply #2 on: July 20, 2021, 04:55:42 PM »
The MOD  You remember was to taper the edge the fixed ejector as a cure for stove pipes.   It was in that discussion some one mentioned a prior Mod to the extractor.  I have not found any other reference to it in my searches.
Logged

Offline Joe L

  • Hero Member
  • *****
  • Posts: 7361
Re: Post on mods to extractor ?
« Reply #3 on: July 21, 2021, 06:13:18 AM »
Oops, you are right.  It is the ejector that is brittle.  I don't remember any changes to the extractor, and I don't think I have made any changes to mine.  Sorry about that.
Joe
Logged
CZ-75B 9mm and Kadet, 97B"E", two P-09's, P-07, P-10C, P-10F, P-10S, MTR

Offline DenStinett

  • Hero Member
  • *****
  • Posts: 6464
  • HALT, Who goes there?
Re: Post on mods to extractor ?
« Reply #4 on: July 28, 2021, 12:35:07 AM »
First off, what issues are you experiencing ?
Can't say I've ever read anything about bending the Extractor .... I know that's how you adjust the Tension on a 1911 Extractor but not the CZ
I have removed the Extractor and filed the inside edge of the Notch in the Bolt and the Barrel where the Extractor sits, to allow the Extractor a bit more inward movement, but that's about it for the Extractor
It's a small, flat part, and would be tough to bend it laterally
Logged
So tell me again how Trump was worse then the 8 years before .... AND what's coming after HIM !

Offline kabong57

  • Full Member
  • ***
  • Posts: 139
Re: Post on mods to extractor ?
« Reply #5 on: July 29, 2021, 12:12:56 AM »
I was reviewing previous posts on mods to cure stove pipes and saw it mentioned.  Just trying to find " the rest of the story" .
Logged
Pages: [1]   Go Up
« previous next »