Author Topic: Mounting an SRO on a milled shadow 2 without a plate  (Read 697 times)

0 Members and 1 Guest are viewing this topic.

Offline bimmerland

  • Jr. Member
  • **
  • Posts: 80
Mounting an SRO on a milled shadow 2 without a plate
« on: January 14, 2025, 09:46:59 PM »
I was looking at mounting a SRO on a milled shadow 2 but it seems that there is not enough width to safely accommodate the mounting screws. Has anyone tried this approach? What is the alternative red dot that will fit

Offline Earl Keese

  • Hero Member
  • *****
  • Posts: 5198
Re: Mounting an SRO on a milled shadow 2 without a plate
« Reply #1 on: January 14, 2025, 09:50:36 PM »
Impact Machine will direct Milan S2 for an SRO.
https://impactcncmachine.com/cz-shadow-2/

Offline m1a_scoutguy

  • Sr. Member
  • ****
  • Posts: 502
Re: Mounting an SRO on a milled shadow 2 without a plate
« Reply #2 on: January 19, 2025, 12:14:43 AM »
https://primarymachine.com/shadow-2-optic-milling/
Here is another solution, compare the two and see which works best for ya.