Just got it, unboxed yesterday. I'm using the bolt action as normal to see how it feels like 3 times, I test the single set trigger and then after 2 of those the trigger won't engage, or fire dry. I take the bolt out and it falls apart. The bolt handle falls off and spring & rod fall on the floor. I'm line wtf? I spend a bit if time on line to reassemble the bolt where the handle finally locks in. Easy enough. Put the bolt back in the action and the trigger won't pull because every time I close the bolt the bolt closes as though the trigger was pulled. I can see it close when I push it down. After an hour of seeing this happen it finally stops. Take it to the range and it works ok but after 30 minutes starts again. I'm not that familiar with bolt actions obviously so and advice would be welcomed.
What do i need to do to this bolt to get it right permanently?
Thanks!
