Razir: Great looking 97B-E. I have one too that David built on a used 2013 model 97B that I sent to him after only firing a few rounds of factory hardball through it. When I got it back from him, it would not feed my 200gr SWC loads that are dimensionally the same as yours and which run in all my 1911s. I am also a 1911 fan and have a local smith, Bunker Arms (he does most of the Cerakote for CGW too) and we determined that the chamber was too short and, also, not concentric. A few turns of his Reamer conformed the chamber to the dimensions he uses in his custom 1911s in .45 ACP and it works perfectly now.
In discussing this with David afterwards, he told me that he had seen other 2013 guns with the same issues and attributed it to "older" tooling at the CZ factory that may have resulted in some "tight" chambers. If you have a qualified gunsmith nearby, you may want to have them do the same thing rather than finding a "work around". I have 5 guns that shoot .45ACP and everyone of them will shoot my SWC handloads without any issues now that I have the 97B-E chamber issue corrected.