K2P grip compatability question

[4runnerguy]

Looking for a slip-on grip for my newly purchased K2P. I have found 2 from Hogue, one looks like a "tube-style" and the other looks almost like it completely covers the grip. They are categorized as CZ clone for the CZ75. Will these fit the K2P and which would work better. Any advice will be appreciated.

[jwc007]

My pick for both the K2P and it's longer sibling, the B6P, has been the full size Hogue Handall.


EAA imported SAR B6P and K2P 9mm Pistols

[AZ_CZ]

+1, use the same one. Really like the palm swell. Remove any oil or lube from the grip then heat it with a  hairdryer and it will slip right on. When it cools, nice a tight.

[4runnerguy]

Thanks for the info. Will be picking up one of these very soon. 

[jwc007]

+1, use the same one. Really like the palm swell. Remove any oil or lube from the grip then heat it with a  hairdryer and it will slip right on. When it cools, nice a tight.

I put them on cold.  It's a struggle, but they do get on eventually. 

[AZ_CZ]

+1, use the same one. Really like the palm swell. Remove any oil or lube from the grip then heat it with a  hairdryer and it will slip right on. When it cools, nice a tight.

I put them on cold.  It's a struggle, but they do get on eventually. 

You're an Animal!

[rich63]

I have a P-07 with the large backstrap installed along with the Hogue Handall grip. Tried to install it cold. Started out alright but was a struggle. Did not want to rip rubber so I stopped. Spray a little windex on the gun grip, inside of the Hogue Handall grip and it went on easy after that. Just my 2 cents. Hope this helps.

rich63

[4runnerguy]

What is the Hogue part number ?

[cntrydawwwg]

Here's a good price and choice of colors. Hogue Rubber Grip Handall Full Size Grip Sleeve https://www.amazon.com/dp/B0014VRS22/ref=cm_sw_r_cp_awd_OucWwbB99DG9H

[4runnerguy]

Thank you cntrydawwwg 

[cntrydawwwg]

You're welcome.

[4runnerguy]

Just ordered my hogue grip from Walmart for less than $8. Thanks again for the help!