« previous next »
Pages: [1]   Go Down

Author Topic: Trigger spring install  (Read 1233 times)

0 Members and 1 Guest are viewing this topic.

Offline kyle04

  • Newbie
  • *
  • Posts: 18
Trigger spring install
« on: September 21, 2016, 07:35:57 PM »
So I installed HBI delta trigger and lightweight trigger and ak safety.  Everything function checks fine.

Went out to shoot and the trigger is not resetting. Fires a round then I go to pull the trigger again and nothing. Pull the charging handle and a live round spits out.

I am sure I installed something wrong,  any idea where to start.
Logged

Offline Wahoo9501

  • Full Member
  • ***
  • Posts: 119
Re: Trigger spring install
« Reply #1 on: September 21, 2016, 07:43:54 PM »
Yes, you didn't get the spring properly set under the firing pin disconnect as shown in the videos. I did the same thing.  Start watching at 9:10

https://www.youtube.com/shared?ci=Sx1PliPA4Es



Sent from my SM-N910V using Tapatalk
« Last Edit: September 21, 2016, 07:47:48 PM by Wahoo9501 »
Logged

Offline SouthernScorpion

  • Jr. Member
  • **
  • Posts: 66
Re: Trigger spring install
« Reply #2 on: September 21, 2016, 08:00:50 PM »
Make sure the roll pin on your trigger shoe is centered and recessed on both sides.
Logged

Offline danno_man

  • Full Member
  • ***
  • Posts: 361
Re: Trigger spring install
« Reply #3 on: September 21, 2016, 08:01:29 PM »
Make sure the disconnector moves freely on the pin.  Mine was causing the a lack of reset, if I kept the trigger back.

A little fluff and buff, and all is good now.
« Last Edit: September 21, 2016, 08:03:22 PM by danno_man »
Logged
Quack

Offline joe_sun

  • Newbie
  • *
  • Posts: 11
Re: Trigger spring install
« Reply #4 on: September 22, 2016, 04:50:17 PM »
Mine had the same issue I had to go back to the stock l spring.
Logged
Pages: [1]   Go Up
« previous next »