Thinner Slide Stop for P-01?

[scottygrape]

Do they make a thinner slide stop for the P-01?  The stock one cuts into my hand while shooting.  I tried swapping the slide stop with one from a CZ-75b but it would lock up the slide and not allow you to rack the slide at all.

[Tok36]

The PCR and P-01 have the same frame width, so you may want to look into a PCR slide stop. It has the profile of the 75B slide stop but has a longer shaft like a P-01 slide stop. I do not know if the PCR slide stop will work in a P-01. Hopefully another forum member has tried it or knows for sure.

[doc171]

The PCR and P-01 have the same frame width, so you may want to look into a PCR slide stop. It has the profile of the 75B slide stop but has a longer shaft like a P-01 slide stop. I do not know if the PCR slide stop will work in a P-01. Hopefully another forum member has tried it or knows for sure.

On the other hand, I have the PO-1 slide stop on my PCR so, I think it may/should work in my opinion.

[wormraper]

The PCR and P-01 have the same frame width, so you may want to look into a PCR slide stop. It has the profile of the 75B slide stop but has a longer shaft like a P-01 slide stop. I do not know if the PCR slide stop will work in a P-01. Hopefully another forum member has tried it or knows for sure.

They're interchangeable. I pulled up an older thread in my search for the sp-01 compact slide release and cz custom said the same thing. P-01 and PCR slide locks can be swapped

[Tok36]

Good to have confirmation on this.

[rhart]

Do they make a thinner slide stop for the P-01?  The stock one cuts into my hand while shooting.  I tried swapping the slide stop with one from a CZ-75b but it would lock up the slide and not allow you to rack the slide at all.

Have you tried to see if a P07 or P09 slide stop would work? They are nice and low profile...