« previous next »
Pages: [1]   Go Down

Author Topic: P-10 backstrap  (Read 1174 times)

0 Members and 1 Guest are viewing this topic.

Offline Bigspur84

  • Newbie
  • *
  • Posts: 9
P-10 backstrap
« on: February 16, 2018, 04:31:48 PM »
Hello,
My new P-10 is arriving tomorrow and I wanted to know what punch tool you needed to replace the backstrap? Also if I need to take the gun apart for like replacing the trigger, what kind and size punches do I need?  Thank you for the help
Logged

Offline 2morechains

  • Hero Member
  • *****
  • Posts: 1113
Re: P-10 backstrap
« Reply #1 on: February 16, 2018, 05:58:06 PM »
Logged

Offline cremaley

  • Sr. Member
  • ****
  • Posts: 798
  • Retired but not forgotten
Re: P-10 backstrap
« Reply #2 on: February 19, 2018, 09:05:44 AM »
I've heard that removing the pin to replace the backstrap is very difficult. Any truth to this?
Logged
CZ 10-PC 9mm (HBI Trigger, CGW Striker 3lb spring, GGI Stainless Guide Rod 15lb spring)
Sig Sauer P365 9mm
Sig Sauer P320 X Carry 9mm
Springfield 911 .380
"Remember the first rule of gunfighting...have a gun"-Jeff Cooper

Offline Rickytick

  • Hero Member
  • *****
  • Posts: 1254
Re: P-10 backstrap
« Reply #3 on: February 19, 2018, 09:44:44 AM »
Its a total pain. I took mine to a gunsmith to punch it out (did not charge me) so i could try all the back straps. After deciding to keep the small one I had him install the HB trigger and put the pin back. I emailed CZ to get a 2018 catalog and give me the pin size, no reply. I did garbage up one end of the pin trying to get it out myself. I needed to try all sizes before ordering talon grips.
« Last Edit: February 19, 2018, 10:58:29 AM by Rickytick »
Logged
Pages: [1]   Go Up
« previous next »