Kadet II on P-01 Omega Threaded

[jslinger]

I just bought an urban grey P-01 Omega threaded.  I attempted to use my Kadet II kit on it.  This kit is fitted to my SP-01, and works flawlessly.  The kit slides onto the frame of the P-01, and I can get the slide catch in.  The part of the slide that cycles fails to go all the way into battery, and I cannot manually force it to its rearward most position.  I had to file the front of the kit to get it to fit my SP-01.  Is there somewhere else I should be looking to file, if it will not fully cycle?
Any help is appreciated.

[painter]

I believe you need the PCR slide stop for the kit to function properly on the P-01.

[jslinger]

Ah.  For some reason I thought it only applied to the PCR.  It came with 2 slide stops, so I'll try the other one.  Otherwise, I'll order the correct one.  Thanks.

[Faraway]

Ok,
Same experince as the OP....  Except I called up CZ parts and ordered the proper slide stop per the website, part number below.

From the CZ website:
"When used on an aluminum-framed compact model (PCR, P-01 and P-06) as well as the steel-framed Compact .40, a specific slide-stop is required for proper last-round hold-open (part number 0440008002, available at no charge through our parts department)."

The slide stop I recieved looked identical to the one included with my Kadet kit and was labeled "kadet 2" in gold lettering..

Can anyone verify if the part number is correct or tell me what the proper part number is?

thank you!

[Faraway]

So the Part numbers are different for the Kadet PCR and the PCR slide stop.

From CZ:

SLIDE STOP KADET FOR P-01, PCR, P-06
FOR ALUMINUM FRAMED COMPACT WITH KADET ADAPTER INSTALLED ONLY
GUNSMITH INSTALLATION IS RECOMMENDED
SLIDE STOP KADET FOR P-01, PCR, P-06
Product Number: 0440008002
Availability: In Stock
Your Price US$35.00


SLIDE STOP PCR
ALSO USED FOR P-01 WITH KADET ADAPTER INSTALLED
GUNSMITH INSTALLATION IS RECOMMENDED
SLIDE STOP PCR
Product Number: 0420008002
Availability: In Stock
Your Price US$35.00

[Faraway]

OK, the slide stop for the PCR works and holds the slide open after the last round.  It does protrude a little further out the pistol than I would think is normal but not horrible.


Below Moved to new thread....

I am now having a FTF about once every five rounds... (light strikes). 
The round will eventually fire off  with a DA trigger pull.

So is it the mainspring or firing pin that needs changing?   

I will start a NEW thread for the FTF problem.