Has anybody tried IMI rubber mag floorplates with their P model CZ?

[CCWLearner]

These are being advertised as working with P-07 and many other pistols:

https://www.imidefense.com/product/pistol-magazine-floorplate/

Has anyone tried them with a P-07, or other P model?

[adrian]

     Hiya CCWLearner and thx for your thread. Have not tried those on my cz's but extra careful with the ones that have no rubber or plastic on the base. The cost of almost 19 bucks sounds a smidge over valued. Take a peek over at Greg Cotes site for the ones avail for your p-07. I do lean towards bases that facilitate a few extra rounds,of course only if ones state allows. Here in arid zona don't think its limited. If ya have more than 25posts up consider WTB p-07 rubber/poly base plate in the wanted ads. Cheers. Be well.

[CCWLearner]

     Hiya CCWLearner and thx for your thread. Have not tried those on my cz's but extra careful with the ones that have no rubber or plastic on the base. The cost of almost 19 bucks sounds a smidge over valued. Take a peek over at Greg Cotes site for the ones avail for your p-07. I do lean towards bases that facilitate a few extra rounds,of course only if ones state allows. Here in arid zona don't think its limited. If ya have more than 25posts up consider WTB p-07 rubber/poly base plate in the wanted ads. Cheers. Be well.

Hey, thanks for the quick response.  I have my stock plastic basepads, both P-10 and P-07 types, and I also ordered a couple of the +2 adapters, which I have tested at the range and they work fine.  I live in a free state so I have no problems ordering high capacity mags.  The reason I'm looking at these +0 IMI basepads with rubber bumpers on them is for purposes of training and competition, dropping mags on the ground or a concrete floor repeatedly.  I agree that the third-party aluminum ones are definitely going to get beat up in that scenario, and the stock plastic ones might take a beating over time also.