« previous next »
Pages: [1]   Go Down

Author Topic: p-10f IDPA  (Read 3087 times)

0 Members and 1 Guest are viewing this topic.

Offline OS

  • Newbie
  • *
  • Posts: 2
p-10f IDPA
« on: February 07, 2019, 06:07:49 PM »
question for the owners - can someone measure the height of cz p-10f with magazine in?
I searched everywhere, even emailed cz-usa (no response yet, it may come later) I can find the dimensions and the listed barely fits the IDPA box, that height is probably without the mag in though.
I wonder P-10f can be used for IDPA.

thanks in advance if someone responds
Logged

Offline Dan-O

  • Jr. Member
  • **
  • Posts: 90
Re: p-10f IDPA
« Reply #1 on: February 07, 2019, 07:29:45 PM »
I?m at work, unless someone else beats me to it, I can get ya covered in a few hours.
Logged

Offline Dan-O

  • Jr. Member
  • **
  • Posts: 90
Re: p-10f IDPA
« Reply #2 on: February 08, 2019, 12:08:12 AM »
5 7/8 from bottom of inserted mag to top of rear sight. 5 3/4 from inserted mag to top of slide.

Logged

Offline Dan-O

  • Jr. Member
  • **
  • Posts: 90
Re: p-10f IDPA
« Reply #3 on: February 08, 2019, 03:12:58 AM »
Logged

Offline GaryCZ

  • Jr. Member
  • **
  • Posts: 31
Re: p-10f IDPA
« Reply #4 on: February 08, 2019, 05:51:19 AM »
I have a P-10 F.
I have an IDPA box.
I put my pistol in the box yesterday.
It's good to go for SSP.
Logged

Offline OS

  • Newbie
  • *
  • Posts: 2
Re: p-10f IDPA
« Reply #5 on: February 08, 2019, 12:28:00 PM »
thank you both Dan-O and GaryCZ.
you guys rock.

looks like I will be using my future p-10f in both IDPA and IPSC
Logged

Offline Joe Allen

  • Full Member
  • ***
  • Posts: 401
Re: p-10f IDPA
« Reply #6 on: February 08, 2019, 02:15:16 PM »
The "F" fits in the box with the 19 round mags. Sadly the 21 round mags with their big, beefy, easy to reload basepads are too big.
Logged

Offline PistolGear

  • Newbie
  • *
  • Posts: 1
Re: p-10f IDPA
« Reply #7 on: April 19, 2019, 03:38:51 PM »
I am planning to run the P-10F this IDPA season in ESP. Installed the HBI Trigger, changed the factory sights to the Trijicon FO sight set and having Dawson build me a taller FO front (currently hits low due to P-10C front).  Gonna run our Operator Magwell and extended base pads.  Should be a lot of fun and all still fits the box! I won't be able to blame the gun for misses, that is for sure.
Logged
Pages: [1]   Go Up
« previous next »