« previous next »
Pages: 1 [2]   Go Down

Author Topic: CZ P-09 Second Pass - Polishing.  (Read 5682 times)

0 Members and 1 Guest are viewing this topic.

Offline Tok36

  • Hero Member
  • *****
  • Posts: 6243
Re: CZ P-09 Second Pass - Polishing.
« Reply #15 on: March 03, 2019, 06:46:10 PM »
^^Thank you for the link Doc. I like learning new tuning options. I will check my P-09 and proceed accordingly. 
Logged
Will work for CZ pics! (including but not limited to all CZ clones)

Offline TaylorD

  • Newbie
  • *
  • Posts: 1
Re: CZ P-09 Second Pass - Polishing.
« Reply #16 on: April 26, 2019, 09:11:41 AM »
Has anyone tried to take machining marks off of the hammer where it engages the sear? I can really notice them when manually cocking the hammer. It would seem like this adds alot of grit to the pulls in single and double. Any advice without ordering new? I live in Canada, so parts availability and cost is amplified greatly.

Thanks

Sent from my LG-H831 using Tapatalk

Logged
Pages: 1 [2]   Go Up
« previous next »